It's a whole set of teeth
Release Time:
2018-10-10 18:17
The first time, the doctor carefully examined the mouth after the bite marks (initial mold).
The second time, according to the model taken out of the initial mold to make individual pallets again bite teeth (fine mold), the mold must be clear, complete, the length is appropriate, the location of the lacing is accurate, and has a strong adsorption force.
On the third visit, the correct jaw position relationship should be determined for the patient and appropriate artificial teeth should be selected. Because "edentulous jaw" disease population inside tooth is absent completely, make mandible bone is in free state.
Therefore, under the guidance of doctors, self-coagulation plastic base or wax leaf embankment must be used as a substitute to help patients recover the original position of upper and lower jaw (central part part relation) and upper part part bracket.
On this basis, the color, size and shape of the appropriate artificial teeth will be selected, and the front teeth will be arranged in the population of the disease, so as to make the patient as far as possible to the middle line of teeth, lips fullness, facial high satisfaction.
The fourth time, the patient tried to wear a complete denture. At this time, the denture was only a prototype, and it was only a wax type. The front and rear teeth were arranged on the base base with wax. The base plate meets the requirements of size, shape and thickness, and is placed in the mouth of the patient for re-examination of the lower 1/3 height of the face, the occlusal relationship between the upper and lower teeth, the fullness of the face shape and the alignment of teeth, etc.
If there is no abnormal condition, it can be sent to the technician's room, and then it is finally completed through the procedures of packing, filling, boiling and polishing. Real tooth loss time is short, alveolar ridge is full, the surface covering mucosal thickness is moderate can consider to choose.
Patients who have had a full denture must have been impressed by the number of visits. Indeed, the repair of complete denture is relatively complicated. From the first clinical visit to the final completion of denture, patients usually need to see the doctor 4 to 5 times within the wearing population, because most of the work needs to be completed within the sick population.
Related News
Types and selection of dentures
When the tooth defect is too much or the abutment surface has been damaged, it is impossible to restore the shape of the tooth and the normal abutment
The material for making "inlay"
When the tooth defect is too much or the abutment surface has been damaged, it is impossible to restore the shape of the tooth and the normal abutment relationship
Patients who first wear complete denture vary greatly in their ability to adapt. Young, with good adaptability to body conditions, and fast recovery of chewing ability
Creator Digital Dental Technology Co.,LTD.
Address: 3rd Floor, No.8 Second Ping Xi Road,Zhuhai, Guangdong, China
Telephone：+86 0756-8678296
Mailbox：service@creator-zh.com